STEP 1: i layered the satin 3 times. Used a bowl that was about 5 1/2 inches and cut around it to make 3 circles!
there is 4 circles in this picture, but you only need 3
STEP 2: cut slits around circle
STEP 3 : cut off tips of each petal. FYI none of this has to be perfect because when you burn it you wont even tell!
STEP 4: now you are going to burn each petal. you will want to curve it like it petal and burn arount the edge. I used a lighter, but you could also use a candle.
this is what it will look like when they are all burned. if it catches fire, you can snip it off and burn it again. i liked the way they looked burnt so i kept it!
STEP 5 : take a piece of tulle the width of your flower. Tie it in a knot, take a second peice of tulle and then tie it in a knot around the first knotted piece, to make it look like this!
STEP 6 : Hot glue it to your petal!
IMPORTANT!!!!!!!
REPEAT STEPS 4 & 5 to make it look like the picture below. Also for this step i tied a third peice of tulle to make it even fuller!
STEP 6: Cut 4 petal apart from the base
STEP 7: glue them randomly like so!
STEP 8: you will make another tulle Knot like you did in STEP 5
STEP 8: bunch it so you can put a drop of hot glue on the knot!
STEP 9: glue it to the whole flower. after everything was glued on i went around and trimmed all the tulle to make it shaped like a flower!
STEP 10: i cut out to pieces of felt. glued one to the bottom of the flower, attached my alligator clip & a pin! Then i glued the other peice of flet inbetween the clip and pin to secure it!
My model was sleeping so you get me!!
I think they turned out so cute, you can wear them in your hair, on jewlery or clothes! i hope you understand everything, this is my first tutorial. im not too good at explaining how i do things. Let me know how i did!
.jpg)
